You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Dear PowerSystems Community.
By using the HydroPumpedStorage constructor, there is the possibility to set up a dynamic model using the dynamic_injector parameter.
For the definition of the dynamic behavior, I would use "Rotor Mass Shaft" model combined with the HYGOV governor.
Is it correct that the dynamic model will only be used in the "turbine" operation mode?
Is there the possibility to use the "Rotor Mass Shaft" to describe the pump behavior?
Best,
Oussama
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Dear PowerSystems Community.
By using the HydroPumpedStorage constructor, there is the possibility to set up a dynamic model using the dynamic_injector parameter.
For the definition of the dynamic behavior, I would use "Rotor Mass Shaft" model combined with the HYGOV governor.
Is it correct that the dynamic model will only be used in the "turbine" operation mode?
Is there the possibility to use the "Rotor Mass Shaft" to describe the pump behavior?
Best,
Oussama
Beta Was this translation helpful? Give feedback.
All reactions