Mainsail / Klipper layer status 0 of 0

[Glenn1963]

This is really minor, but I can't figure out why in OrcaSlicer the layer status doesn't work, but it does in SuperSlicer. I have looked at the SS g-code but cannot see anything that would cause that to be updated.

I have added the M117 command to display the values, so it's no big deal, but I am curious.

Thanks

[Tiwatz]

Did you find a solution to this? I just recently got the same issue.

[Glenn1963]

I haven't, but I haven't tried the 2.0 version either.