You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have recently upgraded to a K1 Max from an Ender V3 Pro (started on that years ago).
I may have what seems to be a dumb question. Obviously on the Ender V3 Pro there is no side fan (the one blowing right onto the plate) This is the fan that is installed on the right wall not the Model/Extruder fan.
My question is that if it is recommended overall (although not required for PLA) to have an enclosure so there are no "Wind Drafts" that could potentially cause warping then why is this fan blowing full blast onto the PLA.
I am getting a lot of warping lately with all of the test temperatures settings i am using for basic PLA.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hello all,
I have recently upgraded to a K1 Max from an Ender V3 Pro (started on that years ago).
I may have what seems to be a dumb question. Obviously on the Ender V3 Pro there is no side fan (the one blowing right onto the plate) This is the fan that is installed on the right wall not the Model/Extruder fan.
My question is that if it is recommended overall (although not required for PLA) to have an enclosure so there are no "Wind Drafts" that could potentially cause warping then why is this fan blowing full blast onto the PLA.
I am getting a lot of warping lately with all of the test temperatures settings i am using for basic PLA.
Thanks for your help.
Rez
Beta Was this translation helpful? Give feedback.
All reactions