2.1.3d-hc32 test

[RooK23]

been trying HC32-MM-ProUI.bin and HC32_Default-NP-ProUI.bin on Aquila X2, both problem are:

• occasionally freeze
• mesh isn't saved after restart
• extruder stepper sound quite loud, seem the accel is off or else (I use BMG)

now I'm back to 2.1.3c which works ok for me, except the mesh that won't saved also..

[classicrocker883]

https://github.com/classicrocker883/MriscocProUI/releases/tag/2.1.3d-hc1

how about this new release?

[RooK23]

I've try the HC32-MM-ProUI.bin, all stepper sound normal, it still get freeze fo a couple of time from initial install, but after everything been set, seems work ok, though the saved mesh won't keep saved after restart

[classicrocker883]

trying to figure out the issue with saving... so when you select Store Settings or Save or issue M500 command is everything normal? that is - does it automatically freeze then restart after? (which it shouldn't do)
or it simply doesn't save after manually turning off and on?

because the mesh not saving after restart happens with the other chip sets GD32 and N32, but it not an issue with UBL versions. the source repo of Mriscoc has the similar issue, which I'm not sure if it's supposed to only save with UBL, and not MM or BLT. I believe all meshes should save and not have to redo them after a restart, so I'm looking into if this is a general thing with Marlin that can be fixed.

[RooK23]

the mesh can be saved and previewed, but as soon the printer restarted (manually turning off and on) it'll be erased.. the freeze happen randomly after fresh install when I did some setting adjustment, but after everything been set, it works ok.. the 'coarse' stepper sound now only happen on extruder motor during retraction, other motors are behave normally..