Setting up KERMIT for telnet over the wifi modem

[laffineuse]

Hi Group,
I am struggling with the Kermit setup to be able to telnet from the IMSAI.
When I do:

• set port uc1
• connect
• ats15=1
  I do get a response of "OK" for AT commands.
  But when I try to dial as in ATDT a80sappleiisbbs.ddns.net:6502 (or any other telnet sites), I immediately get a "NO ANSWER".
  What am I doing wrong?

[laffineuse]

Never mind! I found the solution, I had to run an STA configuration mode first, I was still in AP and therefore unable to access the internet.
Now with the correct configuration mode and the SSDI and password set, Kermit works like a charm.

[jdourish]

I am having the same problem. How did you "run an STA conf mode first"??

[udo-munk]

Is explained in detail in the documentation:
https://thehighnibble.com/imsai8080/configure/#configuring-physical-uart-parameters-speed-data-stop-bits
Section "WiFi Communications"

[jdourish]

Thanks, my IMSAI was already set to STA but I am still getting a no answer message when trying to connect to an external site using either the domain name or ip?

[udo-munk]

The site you try to reach might be down, I always test that with some PC and telnet before, if a site can be reached. Also many sites won't accept plain telnet connections anymore, only ssh encrypted sessions, and CP/M kermit can't do that, it will reject all encryption requests.

[jdourish]

Thanks, I can connect to a number of sites ok using Putty. Will try a few more and see what happens.

[udo-munk]

If putty gets asked about encryption by a remote host, it will answer I can do that. CP/M kermit cannot and will reject the request. This is why I use a plain telnet command line tool for such tests, because that cannot do any encryption offered, and if the host rejects that, it will fail.