{{BOM}}
##Assembly
- As shown in the GIF, join 2 New Axis Cubes{qty:2, cat: PrintedPart}, leaving its walls to the back, then add 2 UC2 cubes{qty:2, cat: PrintedPart}, generating an inverted "L" shaped structure.
- Place the Inner Motor Holder{qty:1, cat: PrintedPart} into the [UC2 cube][UC2 cubes] of the left.
- Join the Stepper Motor{qty:1} with the LBX40-21H4U adapter{qty:1} using 4 M2.5 x 5mm screws{qty:4} and tight with the allen key{qty:1}.
- Take the assembled pieces and join the opposite side of the LBX40-21H4U adapter with the Axis Control{qty:1}, using 2 M2.5 x 5mm screws{qty:2}
Place the Stepper Axis Controller:{PageStep}
- Using the Allen key{qty:1} and 4 M3 x 12mm screw{qty:4} screw the Axis Control into the wall of the axis cube on the edge.
Objective arm:{PageStep}
- Using 3 M3 x 10mm screw{qty:3} place the Objective arm{qty:1, cat: PrintedPart} with the Allen key, leave the middle screw pointing to the stepper motor.
- Using the 2 axis cube tops{qty:2, cat: PrintedPart} close the new axis cubes. For that take 4 M3 x 10mm screw{qty: 4} and tight them with the Allen key, then do the same with the 2 UC2 cubes.
Carefully screw the needed objective{qty: 1} into the Objective arm.
! Do not touch the lens directly to avoid getting it dirty or scratched.
#Now it's ready!