Why I see multiple setpoints in some Danffoss TRVs? #4048
Replies: 6 comments 5 replies
-
cc @AlCalzone |
Beta Was this translation helpful? Give feedback.
-
Please make a driver log of a re-interview, loglevel |
Beta Was this translation helpful? Give feedback.
-
Yes, I will make re-interview when I am on site, but I wanted to say, that I am sure that when I did the first interview a year ago, there was single Setpoint property. Now after 1 year there are 2 or some TRVs has even 3. I think if I will re-interview there will be again only one... |
Beta Was this translation helpful? Give feedback.
-
OK, I did re-interview and these 2 fake Setpoint properties has gone. In UI I see only one setpoint as expected: interview was completed: and logs and previous and after debug are attached. thanks for looking to it. |
Beta Was this translation helpful? Give feedback.
-
thanks for explanation. I am surprised interview log are missing as I grabbed whole structure like this (and logs were enabled to file): what else i can do to get interview logs? |
Beta Was this translation helpful? Give feedback.
-
I did not have Driver log enabled before, so I did another interview on other ghost setpoint TRV Attached is log incl. interview lines. After interview the issue was fixed again. A bit strange is that all TRVs (I have 8 of them) has this ghost setpoint issue, but if you think it is still related to |
Beta Was this translation helpful? Give feedback.
-
Hi community,
I'd like to ask following question:
When I was adding my Danfoss TRVs a year ago, when I was adding the node, z-w js ui detected them with single Setpoint property. Now after one year, when I do regular system check, I see at some of them more then one Setpoint property. I see even 3 of them defined at some TRVs. ie.
3-67-0-setpoint-1
and3-67-0-setpoint-0
Any idea why this is happening and how to remove them?
Beta Was this translation helpful? Give feedback.
All reactions